Installation of LED Panels

Installation of LED Panels

Contact

Service

LED lighting

Popular categories

Home Installation of LED Panels

The installation and assembly of our LED Panels are very easy and quick.
On this page we will explain how to connect and install your new LED Panels in a few quick and easy steps.

Requirements:

LED Panel
LED Driver (supplied with the LED Panels)
Power supply cable with WAGO clips

Instructions:


Step 1: First, you need to connect the LED Driver to the power supply cable. This is done by connecting the driver cords and the power supply cable with the WAGO clips (or a terminal block)	Step 3: Plug the driver into the LED Panel, pay attention to the arrows and make sure to tighten them securely.
Step 2: Plug the power supply cable into your outlet

Demonstration video:

Requirements:

LED Panel
LED Panel surface mounting frame
Screws - supplied (4 green plugs, 4 long screws and 4 small screws)
Screwdriver

Instructions:


Step 1: Screw the two sides of the mounting frame to the ceiling, here the green plugs and the long screws are required.	Step 2: On one side of the frame, screw one of the two remaining parts of the mounting frame set. PLEASE NOTE: Leave one of the two sides open.


Step 3: Slide the LED Panel into the mounting frame	Step 4: Now also close the last side of the frame, by screwing on the remaining part.

Demonstration video:

Requirements:

LED Panel
LED Panel Suspension system
Screwdriver
Power drill

Instructions:


Step 1: First, you need to adjust the cable length to the height you need. This is done by loosening the screw of the tube and pulling the cable through as far as you want, you now have 4 pieces of cable. When the correct length is obtained, close the screw again. Do this with both cables. PLEASE NOTE: Make sure that both cables are of the same length	Step 2: Screw the four suspension triangles to the back of your panel. Make sure that the upper and lower triangles are facing each other, i.e. along the edge of the panel.


Step 3: Clip the cables to the suspension triangles.	Step 4: You can now cut off the piece of cable that hangs from the side of the middle of the tube. (Piece of the cable where nothing is attached)


Step 5: Drill the screws through your ceiling in one of the supplied round tubes.	Step 6: Now secure the cables to the screws on your ceiling.

Step 7: You can screw your driver to the panel.

Demonstration video:

Check out and subscribe to our YouTube channel for many more demonstrations on our LED Lighting.

If you have any questions, do not hesitate to contact our customer service:
+31 20-2600008 or info@ledpanelwholesale.co.uk
We will be happy to help you!

Is the answer to your question missing? Contact us

Score 8,8/10 21.580 reviews

What our clients are saying

"Fast and professional support." 10/10 - David. 3-3-2021

* All prices are excluding VAT

Besparingscalculator

Informatie
Aantal te vervangen spots
Wattage huidige spots
Wattage Led spots
Branduren per dag
Branduren per jaar
Prijs per kWh	€

Gemiddelde levensduur non-stop gebruik
	Uren	Dagen	Jaren
Gloeilamp	1000	42	0,12
Halogeenlamp	2000	83	0,23
TL-buis	10000	208	0,57
Spaarlamp	12000	500	1,37
LED-lamp	50000	2083	5,71

1 Lamp per jaar

Verbruik

Stroomkosten

Verbruik 1 gloeilamp

kWh

€

Verbruik 1 LED-lamp

kWh

€

Sluiten

Verbruik / Kosten

Huidige verlichting:

Ledverlichting:

U Bespaart p/jaar: